Cement Wall Putty

Approx. Rs 850 / BagGet Latest Price

Service Details:

Wall putty is a unique formulation of white cement and high performance chemicals and polymers which can be applied on damp as well as dry surfaces.

Advantages:

• White cement based 2-in-1 Wall Putty
• White, smooth & glossy finish
• Does not allow paint to flake
• Protects paint from moisture
• Curing is not required
• Ideal for interior & exterior walls

Application:

• Clean & Pre wet the plaster surface before applying Lata Finsh Putty.
• Make a Lata finish Putty paste which can be used in 2 hours time.
• Apply the first coat of putty on pre wet surface from bottom to upward direction with putty blade.
• After drying of first coat of putty clean the surface with smooth dry cloth followed by wet cloth.
• Apply second coat of putty after about 3.0 hrs of first coat.
• Allow the surface to dry for minimum 12 hours.
• The Putty to be applied in two coats at a maximum thickness of 1.5 mm.
• Before paint application clean the putty surface for all the loosely adhered material and use very fine water resistant emery paper ( preferably more than 500 Nos) only if there are marks of putty blade on the surface.
• During application of putty the surface should be protected from direct sunlight till the two coats of putty are dried.

Mixing:

• Mix LataFinish Wall Putty with around 35% of clean/potable water to make a paste of workable consistency
• The mixing has to be done till a uniform paste is prepared.
• Once the paste is prepared it is left for 5 to 10 minutes before application to ensure complete reactions of admixtures present in putty.
• Mix only that much quantity of putty paste which can be used in 2 hours time.

Surface Preparation:

• The Cement Plaster Surface should be cured for 28 days to achieve proper strength before application of Wall Putty.
• The Surface should not have any Structural cracks.
• Any Non Structural Cracks to be treated first with appropriated crack filler before applying putty.
• Ensure the surface is cleaned from all the dust , grease & loose materials with the help of emery stone / putty blade/ wire brush together with clean water.
• Pre wet the surface before applying Wall Putty.